D-Link DG-104SH Especificaciones descargar pdf (Pagina 70)

DG-104SH VoIP Station Gateway



The DG-104SH VoIP gateway offers a line-at-a-time prompt and response scheme to execute various

configuration instructions. The interface displays a single prompt character ggd/jointfilesconvert/387032/bg> when it is ready to accept a

command (ex. ggd/jointfilesconvert/387032/bg>set or ggd/jointfilesconvert/387032/bg>show).

Typing a question mark after the ggd/jointfilesconvert/387032/bg> prompt will display a list of helpful user commands. Please note that all

characters must be entered in lower case. For the sake of explanation, all command line examples in this chapter

are in bold type.

See below for a list of some of the most commonly used commands, parameter(s), and examples of their usage.

!

nwd/jointfilesconvert/387032/bg system reboot

Definition: This command is used to restart the device.

Parameter(s): None.

Example: nwd/jointfilesconvert/387032/bg system reboot

nwd/jointfilesconvert/387032/bg save changes

Definition: This command is used to save configuration changes into flash and then restart the device.

Parameter(s): None.

Example: nwd/jointfilesconvert/387032/bg save changes

nwd/jointfilesconvert/387032/bg factory reset

Definition: This command is used to change all of the configuration data to the default values, save the

new configuration data into flash, and then restart the device.

Parameter(s): None.

Example: nwd/jointfilesconvert/387032/bg factory reset

nwd/jointfilesconvert/387032/bg un <USERNAME>

Definition: This command sets the username if there is a username string, or shows the

username/password if only nwd/jointfilesconvert/387032/bg un is typed.

Parameter(s): <USERNAME, maximum string length is 12 characters>

Example: nwd/jointfilesconvert/387032/bg un 123456789012

nwd/jointfilesconvert/387032/bg pw <PASSWORD>

Definition: This command sets the password if there is a password string, or shows the

username/password if only nwd/jointfilesconvert/387032/bg pw is typed.

Parameter(s): <PASSWORD, maximum string length is 12 characters>

Example: nwd/jointfilesconvert/387032/bg pw

nwd/jointfilesconvert/387032/bg slic <0|1>

Definition: This command changes the Subscriber Line Interface Circuit (SLIC) state to standby or

active, or shows the SLIC state if only nwd/jointfilesconvert/387032/bg slic is typed.

Parameter(s): <slic state, 0 : standby, 1 : active >

Example: nwd/jointfilesconvert/387032/bg slic 0

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 78 79

Sin comentarios

D-Link DG-104SH Especificaciones Pagina 70