D-Link DSL-2750B Manual de usuario descargar pdf (Pagina 72)

Section 3 - Configuration

D-Link DSL-2750B User Manual

ROUTING SETUP

Enter the destination network address, subnet mask, gateway AND/OR available WAN interface then click "Apply" to add the entry to the routing

table. A maximum 32 entries can be configured Allows you to configure RIP (Routing Information Protocol). To activate RIP for the device, select

the 'Enabled' radio button for Global RIP Mode. To configure an individual interface, select the desired RIP version and operation, followed by

placing a check in the 'Enabled' checkbox for the interface. Click the 'Apply' button to save the configuration, and to start or stop RIP based on the

Global RIP mode selected.

To access the Routing setting window, click on the Routing button under the ADVANCED tab.

Routing -- Static Route

Please click the Add or Edit button to set a static routing policy in the list.

Please type the Destination Network Address and Subnet Mask.

Please choose type Use the Gateway IP, Use the IPv4 interface or Use

the IPv6 interface to be the routing interface.

Click the Apply the button to save the configuration.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 111 112

Comentarios a estos manuales

Sin comentarios

D-Link DSL-2750B Manual de usuario Pagina 72

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores D-Link DSL-2750B