D-link WIRELESSADSLROUTER DSL-G604T Manual de usuario Pagina 85
- Pagina / 92
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
DSL-G604T 54Mbps Wireless ADSL2/2+ Modem/Router Manual
Networks attached to the Internet are assigned class types that determine the maximum number of
possible hosts per network. The previous figure illustrates how the net and host portions of the IP
address differ among the three classes. Class A is assigned to networks that have more than 65,535
hosts; Class B is for networks that have 256 to 65534 hosts; Class C is for networks with less than 256
hosts.
IP Network Classes
Class Maximum
Number of
Networks in
Class
Network Addresses
(Host Portion in
Parenthesis)
Maximum Number of
Hosts per Network
A 126 1(.0.0.0) to 126(.0.0.0) 16,777,214
B 16,382 128.1(.0.0) to 191.254(.0.0
)
65,534
C 2,097,150 192.0.1(.0) to 223.255.254
(.0)
254
Note: All network addresses outside of these ranges (Class D and E) are either reserved or
set aside for experimental networks or multicasting.
When an IP address's host portion contains only zero(s), the address identifies a network and not a
host. No physical device may be given such an address.
The network portion must start with a value from 1 to 126 or from 128 to 223. Any other value(s) in
the network portion may be from 0 to 255, except that in class B the network addresses 128.0.0.0 and
191.255.0.0 are reserved, and in class C the network addresses 192.0.0.0 and 223.255.255.0 are
reserved.
The value(s) in the host portion of a physical device's IP address can be in the range of 0 through 255
as long as this portion is not all-0 or all-255. Values outside the range of 0 to 255 can never appear in
an IP address (0 to 255 is the full range of integer values that can be expressed with eight bits).
The network portion must be the same for all the IP devices on a discrete physical network (a single
Ethernet LAN, for example, or a WAN link). The host portion must be different for each IP device —
or, to be more precise, each IP-capable port or interface — connected directly to that network.
The network portion of an IP address will be referred to in this manual as a network number; the host
portion will be referred to as a host number.
To connect to the Internet or to any private IP network that uses an Internet-assigned network number,
you must obtain a registered IP network number from an Internet-authorized network information
center. In many countries you must apply through a government agency, however they can usually be
obtained from your Internet Service Provider (ISP).
If your organization's networks are, and will always remain, a closed system with no connection to the
Internet or to any other IP network, you can choose your own network numbers as long as they
conform to the above rules.
If your networks are isolated from the Internet, e.g. only between your two branch offices, you can
assign any IP Addresses to hosts without problems. However, the Internet Assigned Numbers
Authority (IANA) has reserved the following three blocks of IP Addresses specifically for private
(stub) networks:
Clas
s
Beginning
Address
Ending
Address
A 10.0.0.0 10.255.255.25
5
85
- DSL-G604T 1
- Wireless ADSL Router 1
- User’s Guide 1
- FCC Warning 2
- CE Mark Warning 2
- Warranty and Registration 3
- TABLE OF CONTENTS 4
- About This User’s Guide 6
- Before You Start 6
- Installation Requirements 6
- Record your info here 7
- Introduction 8
- Front Panel 11
- Rear Panel 12
- Wireless LAN Basics 12
- About 802.11g Wireless 13
- Hardware Installation 15
- Factory Reset Button 18
- Power On Router 18
- WAN Configuration Summary 19
- Configure IP Settings 20
- Windows Me 22
- Windows NT 4.0 23
- Figure 3-2. Home – Setup 25
- Wireless 30
- WAN Configuration 31
- ATM VC Setting 33
- Dynamic IP Address 34
- Static IP Address 35
- Bridge Mode 38
- LAN Configuration 41
- Figure 4- 11. DNS window 43
- Dynamic DNS 44
- Advanced Configuration 45
- Virtual Server 46
- LAN Clients 46
- Figure 5- 4. SNMP window 48
- Filters 49
- Bridge Filters 50
- Routing 50
- Firewall 52
- Figure 5- 9. Firewall window 53
- Figure 5- 10. RIP window 54
- ATM VCC 56
- Wireless Management 57
- Wireless Performance 60
- Remote Log 64
- Firmware 67
- Miscellaneous 68
- Device Info 71
- DHCP Clients 72
- Statistics 75
- Figure 7- 8. Help Window 78
- Technical Specifications 79
- IP Address Setup 81
- IP Concepts 84
- Microfilters and Splitters 88
- Line Splitter Installation 89
- International Offices 90
- Registration Card 91
Relacionado con productos y manuales para Hardware D-link WIRELESSADSLROUTER DSL-G604T
Hardware D-link AirPlus DI-524 Manual de usuario
(95 paginas)
(95 paginas)
Hardware D-link DIR-301 Manual de usuario
(67 paginas)
(67 paginas)
Hardware D-link AIR DWL-610 Manual de usuario
(51 paginas)
(51 paginas)
Hardware D-link DFM-560EL Manual de usuario
(71 paginas)
(71 paginas)
Hardware D-link VOIP TA DVG-5112S Manual de usuario
(62 paginas)
(62 paginas)
Hardware D-link WBR-2310 Manual de usuario
(78 paginas)
(78 paginas)
Hardware D-link DIR-455 Manual de usuario
(93 paginas)
(93 paginas)
Hardware D-link DFE-530TX+ Manual de usuario
(21 paginas)
(21 paginas)
Hardware D-link DI-604 Manual de usuario
(79 paginas)
(79 paginas)
Hardware D-link DCM-202 Manual de usuario
(7 paginas)
(7 paginas)
Hardware D-link DFE-530TX+ Manual de usuario
(27 paginas)
(27 paginas)
Hardware D-link DFL-1100 Manual de usuario
(2 paginas)
(2 paginas)
Hardware D-link DI-634M Manual de usuario
(94 paginas)
(94 paginas)
Hardware D-link DI-304M Manual de usuario
(105 paginas)
(105 paginas)
Hardware D-link VDI-624 Manual de usuario
(91 paginas)
(91 paginas)
Hardware D-link DI-LB604 Manual de usuario
(92 paginas)
(92 paginas)
Hardware D-link WAP54G Manual de usuario
(67 paginas)
(67 paginas)
Hardware D-link DI-524 Manual de usuario
(95 paginas)
(95 paginas)
Seagate TS-EC880 Pro manuály
Uživatelské manuály a uživatelské příručky pro NAS a úložné servery Seagate TS-EC880 Pro.
Poskytujeme 1 manuály pdf Seagate TS-EC880 Pro ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentarios a estos manuales