D-Link DSL-300G Guía de usuario descargar pdf (Pagina 24)

DSL-300 ADSL Modem User’s Guide

Configure the Internet Connection

Now that you have accessed the web-based manager, you can configure the device for connection to the Internet.

For PPPoE and PPPoA connections, you will need to enter a User Name and Password used by your ISP or

ADSL service provider for authentication purposes. This information is stored in the Modem’s memory and you

will not need to enter this again. If you are using PPPoE on the Modem for your Internet connection and you

have not been instructed to change any connection settings for the Modem, then all you need to do is to enter the

authentication information (user name and password).

If your ADSL service is using a “Bridged Ethernet” (RFC 1483) connection, your ISP or ADSL service provider

will supply special software to install on your computer. This software will also require a user name and

password for your account. In this case, the user name and password are stored in your computer’s memory.

The default connection method used by the Modem is PPPoE. If you are using a PPPoA, IPoA, or Bridged

Ethernet (RFC 1483) connection, you need to change the connection method. If you are using a connection type

other than PPPoE, skip ahead to the section titled, Changing the Connection Type. Once the connection type has

been changed, read the section corresponding to your ADSL service connection type to configure your Internet

connection.

PPPoE Connections

In the Account Configuration window, follow these steps to establish the Internet connection using PPPoE:

1. In the User Name entry field, type the user name used to identify your account.

2. In the Password entry field, type the password used to authenticate your account

3. DO NOT change the Authentication method unless your ADSL service provider or ISP has instructed

you to change it. By default, the pap protocol is selected. If you are told to change this, select chap

from the pull-down menu.

4. Leave the Connect on Demand option enabled in the pull-down menu. This simply means that the

Modem will begin the connection process when it restarts.

5. Leave Idle Time set to the 0. This tells the Modem to maintain the “always on” connection, even when

you are not using the Internet.

6. Click OK.

7. A new message appears:

8. Click OK. The information you have just entered will be saved to the Modem’s flash memory.

Note: If you have been instructed to change the VPI/VCI settings or to enter the AC

Name information, skip ahead to the System Settings section in the next chapter.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Sin comentarios

D-Link DSL-300G Guía de usuario Pagina 24