D-Link DGS-3200-16 - Switch - Stackable Guía de instalación descargar pdf (Pagina 26)

xStack

DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch

Connect to RPS

The DPS-200 is connected to the Master Switch using a 14-pin DC power cable. A standard, three-pronged AC power cable

connects the redundant power supply to the main power source.

Figure 2- 17. Connecting the DGS-3200-24 to the DPS-200

1. Insert one end of the 14-pin DC power cable into the receptacle on the switch and the other end into the redundant power

supply.

2. Using a standard AC power cable, connect the redundant power supply to th e main AC power source. A green LED on

the front of the DPS-200 will glow to indicate a successful connection.

3. Re-connect the switch to th e AC power source. The n LED ind icator will show that a red undant power supply is now in

operation.

4. No change in switch configuration is necessary for this installation.

NOTE: See the DPS-200 documentation for more information.

CAUTION: Do not use the DGS-3200-24 with any redundant power

system other than the DPS-200.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Sin comentarios

D-Link DGS-3200-16 - Switch - Stackable Guía de instalación Pagina 26