D-Link DI-2000 Series Manual de usuario descargar pdf (Pagina 21)

DI-2000 Series Routers hardware installation manual

7 BRI S/T

ISDN BRI S/T

interface

Connect to S/T interface( RJ45) of ISDN network

terminal(NT1) through the port

8 ACTIVE

ISDN BRI S/T

interface is active

When the line is enabled and D channel is active, the

indicator will glint.

9 TR

Selective switches

of 100Ω terminal

resistance

TR should be set as ON under point-to-point

communication. TR of two general bus terminal

should be set as ON under general bus

communication , while other DI-2006 routers should

be set as OFF.

3.3 Port Connection Specification

3.3.1 PIN Specification of Ports

The DI-2006 router has a serial port, a Ethernet port and a ISDN S/T interface. PIN

description of each port is as follows:

1. Serial ports

The DI-2006 router has one serial port. The jacks are three rows, 44 pins and high

density. They can be deployed to be synchronous or asynchronous methods, so they

can connect to synchronous MODEM(such as TAINET T-1496) or asynchronous

MODEM(such as 3Com USR) for entering special networks. For synchronous method,

the DI-2004 router also support the physical protocol of V.35, capable of connecting to

baseband MODEM(such as ASCOM AM64000A ) with a maximum speed of 2Mbps to

achieve the high-speed access goal.

PIN description of serial ports on the DI-2006 is shown asTable 3-1:( PIN in the table

and figure is signed in corresponding location of the jack)

2. The Console port

The DI-2006 router has a Console port with the standard RJ45 jack. The port is

connected to terminals(such as STAR-510G

) or serial ports of PC with the special

Console cable, then terminal emulate software can be used to deploy and monitor the

DI-2006 router.

Pin description is shown as Figuer 2-3.

3. Ethernet port

The Ethernet port of the DI-2006 router offers two physical interfaces:

AUI(Attachment Unit Interface) and TP interface(twisted-pair interface). While used,

the router can connect to HUB from TP interface through twisted-pair cable, or the

router can connect to HUB, thin cable or thick cable from AUI through a special switch

box. Pin number order of TP interface is the same to Console port. Its distribution is

shown as Figure 1-2-3.

Pin description of TP interface(twisted-pair interface) is shown as Table 2-5.

- 18 -

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Comentarios a estos manuales

Sin comentarios

D-Link DI-2000 Series Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Redes D-Link DI-2000 Series