D-Link DSN-610 Manual de usuario descargar pdf (Pagina 2)

DSN-6000 series Firmware Release Notes

Revision History and System Requirement:

Firmware Version

Date

Model

Hardware

Version

V2.0.2 2011/9/1

600

series

, including

DSN-610/ 640, DSN-6110/ 6410

V2.1.0 2011/11/11

DSN

6000 series, including

DSN-610/ 640, DSN-6110/ 6410

Upgrading Instructions:

1. After upgrading from 2.0.2(or 2.0.1) to 2.1.0, the system needs a cold reboot, which

means you need to power off the system and power back on again.

2. In order to support 6G SATA HDD, this release of firmware forces 6G SATA to run at

3Gb speed with DSN-654 bridge board. The side effect is that the system will not

support 1.5Gb SATA drives anymore. New HDD compatibility list will remove

SATA 1.5Gb HDD.

Firmware upgrade steps for all DSN-6000 series

1. Stop all IO from hosts/servers

2. Go to “Maintenance” -> “Upgrade”

3. Browse the latest firmware file and click “Confirm” to start upgrading

4. After completion, system rebooting message will pop up.

5. Please power off directly without rebooting. Wait for a minute and power

on. The system should be up and running normally.

Firmware upgrade steps from DSN-6110/ 6410 (in firmware v2.0.1) to DSN-6120/ 6420

1. Power on DSN-6110 with FW earlier than FW 2.1.0 (single mode, with replication enabled)

2. Upgrade to FW 2.1.0

3. Cold reboot (power off and power back on)

4. Change single mode to dual mode.

5. Shutdown and power off. Plug in Controller 2(FW earlier than 2.1.0), and power on.

6. Controller2 will be in lockdown mode because of FW mismatch.

7. Do firmware synchronization. Wait for Controller2 to reboot.

After Controller2 is online, you should have a DSN-6120 system with FW2.1.0 and

replication still enabled.

1 2 3 4

Sin comentarios

D-Link DSN-610 Manual de usuario Pagina 2