D-Link DKVM-IP8 Guía de instalación descargar pdf (Pagina 12)

Step 11

Connect the Ethernet and/or modem, ISDN, depending how you want to access DKVM -IP8

switch.

The rear side of DKVM -IP8 switch provides a RJ -45 connector for Ethernet. The connector is

used either for a 100 Mbps 100B ASE-TX connection or for a 10 Mbps 10BASE -T connection.

The adapter can sense the connection speed and will adjust to the appropriate operation mode

automatically.

10 Mbps Connection

For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3 , 4, or 5 UTP cable.

To establish a 10 Mbps connection, the cable must be connected to a 10BASE -T hub.

 Make sure that the cable is wired appropriately for a standard 10BASE -T adapter.

 Align the RJ-45 plug with the notch on the adapter’s connector and inser t it into the

adapter’s connector.

100 Mbps Connection

For 100BASE-TX Fast Ethernet networks, DKVM -IP8 switch supports Category 5 UTP cabling.

To establish a 100 Mbps connection, the cable must be connected to a 100BASE -TX hub.

 Make sure that the cable is wired appropriately for a standard 100BASE -TX adapter.

 Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the

adapter’s connector.

Note: Before attempting to connect anything to the DKVM -IP8 switch or your computers,

please ensure that all your computers and devices are power off.

INTERNET

Modem

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Sin comentarios

D-Link DKVM-IP8 Guía de instalación Pagina 12