D-Link DSN-1100-10 - xStack Storage Area Network Array Hard Drive Guía de usuario descargar pdf (Pagina 50)

50 Chapter 4 Installing the XStack Storage

4.7 Connecting to the XStack Storage Management Port

Connecting a PC to the XStack Storage management port lets you configure and manage the

XStack Storage unit. This procedure requires a PC with an installed NIC and an appropriately

configured Ethernet cable.

 To connect the PC directly to the XStack Storage management port, use a cross-over cable.

 To connect the PC to the XStack Storage unit using a hub or switch, use a straight-through

cable.

To connect to the XStack Storage management port, use the following procedure.

1. Connect either end of an Ethernet cable to a NIC installed in the PC that will be used to

manage and monitor the XStack Storage unit.

2. Connect the other end of the cable into the XStack Storage Mgmt Ethernet port. Facing the

back of the XStack Storage unit, the management port is the rightmost RJ-45 connector:

– To view this port on the XStack DSN-3200, see

Figure 3-6 on page 37.

– To view this port on the XStack DSN-3400, see

Figure 3-8 on page 39.

If you want to configure the XStack Storage unit for email alert notifications,

be sure the management port can communicate via Ethernet with your mail

server.

XStack Storage management and data activities must be separate. This

means you cannot connect the same NIC to the management and host

network connection ports. Rather, one NIC must connect to the management

port and a different NIC, either in the same PC or a different PC, must

connect to the host network connection port(s).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 196 197

Sin comentarios

D-Link DSN-1100-10 - xStack Storage Area Network Array Hard Drive Guía de usuario Pagina 50