D-Link DWL-510 Guía de instalación descargar pdf (Pagina 18)

Beacon Interval: Beacons

are packets sent by an access

point to synchronize a wireless

network. Specify a beacon

interval value. Default (100) is

recommended.

RTS Threshold

: This

value should remain at its

default setting of 2432. If you

encounter inconsistent data

ﬂow, only minor modiﬁcations

to the value range between 256

and 2432 are recommended.

Fragmentation: T

his value

should remain at its default setting

of 2346. If you experience a high

packet error rate, you may slightly

increase your fragmentation threshold within the value range of 256 to 2346. Setting the

fragmentation threshold too low may result in poor performance.

DTIM Interval (Beacon Rate): (Delivery Trafﬁc Indication Message) Enter a value

between 1 and 255 (default is 3) for the Delivery Trafﬁc Indication Message (DTIM.)

A DTIM is a countdown informing clients of the next window for listening to broadcast

and multicast messages.

TX Rates: Select the transmission rate for the network. The default setting is Auto.

Mode Setting: For utmost speed, select G Mode to include only 802.11g devices

in your network. Select Mix Mode to include 802.11g and 802.11b devices in your

network.

Preamble: Short Preamble is the default setting. (High trafﬁc networks should use the

shorter preamble type.) The preamble deﬁnes the length of the CRC block (Cyclic

Redundancy Check is a common technique for detecting data transmission errors) used

in communication between the access point and the wireless network adapters.

Advanced > Filters

Advanced > Performance

SSID Broadcast: (Service Set Identiﬁer) Enable or Disable (default) the broadcast of

the SSID name across the network. SSID is a name that identiﬁes a wireless network.

All devices on a network must use the same SSID to establish communication.

Antenna Transmit Power: Select the transmission power of the antenna. Limiting

antenna power can be useful for security purposes.

Using the Conﬁguration Utility in AP Mode (continued)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 78 79

Sin comentarios

D-Link DWL-510 Guía de instalación Pagina 18