D-Link DWL-510 Guía de instalación descargar pdf (Pagina 51)

Beacon Interval: Beacons are

packets sent by an access point to

synchronize a wireless network.

Specify a beacon interval value.

Default (100) is recommended.

RTS Threshold:

This value

should remain at its default

setting of 2432.

If you encounter

inconsistent data ﬂow, only minor

modiﬁcations to the value range

between 256 and 2432 are

recommended.

Fragmentation: This value

should remain at its default

setting of 2346. If you experience

a high packet error rate, you may slightly increase your fragmentation threshold within

the value range of 256 to 2346. Setting the fragmentation threshold too low may result

in poor performance.

DTIM Interval (Beacon Rate): (Delivery Trafﬁc Indication Message) Enter a value

between 1 and 255 (default is 3) for the Delivery Trafﬁc Indication Message (DTIM.)

A DTIM is a countdown informing clients of the next window for listening to broadcast

and multicast messages.

TX Rates: Select the transmission rate for the network. The default setting is Auto.

Mode Setting: For utmost speed, select G Mode to include only 802.11g devices in your

network. Select Mix Mode to include 802.11g and 802.11b devices in your network.

Preamble: Short Preamble is the default setting. (High trafﬁc networks should use the

shorter preamble type.) The preamble deﬁnes the length of the CRC block (Cyclic

Redundancy Check is a common technique for detecting data transmission errors) used

in communication between the access point and the wireless network adapters.

Using the Conﬁguration Utility in Router Mode (continued)

Advanced > Performance

SSID Broadcast: (Service Set Identiﬁer) Enable or Disable (default) the broadcast of

the SSID name across the network. SSID is a name that identiﬁes a wireless network.

All devices on a network must use the same SSID to establish communication.

Antenna Transmit Power: Select the transmission power of the antenna. Limiting

antenna power can be useful for security purposes.

Authentication:

Select Open System to communicate the key across the network.

Select Shared Key to limit communication only to those devices that share the

same WEP settings.

Select WPA-PSK to select Wi-Fi Protected Access without a RADIUS server.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 78 79

Comentarios a estos manuales

Sin comentarios

D-Link DWL-510 Guía de instalación Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan D-Link DWL-510