D-Link DWL-2000AP - AirPlus Xtreme G Especificaciones descargar pdf (Pagina 40)

1.The computer used to configure the DWL-2000AP cannot ac-

cess the Configuration menu.

Check that the Ethernet LED on the DWL-2000AP is ON. If

the LED is not ON, check that the cable for the Ethernet

connection is securely inserted.

Check that the Ethernet Adapter is working properly. Please

see item 3 (Check that the drivers for the network

adapters are installed properly) in this Troubleshooting

section to check that the drivers are loaded properly.

Check that the IP Address is in the same range and subnet

as the DWL-2000AP. Please see Checking the IP Address

in Windows XP in the Networking Basics section of this

manual.

Note: The IP Address of the DWL-2000AP is 192.168.0.50. All the computers on

the network must have a unique IP Address in the same range, e.g., 192.168.0.x.

Any computers that have identical IP Addresses will not be visible on the

network. They must all have the same subnet mask, e.g., 255.255.255.0

Do a Ping test to make sure that the DWL-2000AP is

responding. Go to Start>Run>Type Command>Type ping

192.168.0.50. A successful ping will show four replies.

Troubleshooting

This Chapter provides solutions to problems that can occur during the installation and

operation of the DWL-2000AP Wireless Access Point. We cover various aspects of the

network setup, including the network adapters. Please read the following if you are having

problems.

Note: If you have

changed the default IP

Address, make sure to

ping the correct IP

Address assigned to

the DWL-2000AP.

Note: It is recommended that you use an Ethernet connection to

configure the DWL-2000AP Wireless Access Point.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 52 53

Sin comentarios

D-Link DWL-2000AP - AirPlus Xtreme G Especificaciones Pagina 40