D-Link DXS-3600 Series Guía de instalación descargar pdf (Pagina 22)

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide

After correctly configuring the terminal, plug the power cable into the power receptacle on the back of the switch. The

boot sequence will appear in the terminal.

Set the terminal emulation software as follows:

• Select the appropriate serial port (COM1 or COM2).

• Set the data rate to 115200 baud.

• Set the data format to 8 data bits, 1 stop bit, and no

parity.

• Set flow control to none.

Figure 4-1 COM1 Properties - Port Settings

• Under Properties, select VT100 for Emulation mode.

• Select Terminal keys for Function, Arrow and Ctrl keys.

Make sure to use Terminal keys (not Windows keys)

are selected.

Figure 4-2 COM1 Properties - General Settings

NOTE: When using HyperTerminal with the Microsoft® Windows® 2000 operating system, ensure

that Windows 2000 Service Pack 2 or later is installed. Windows 2000 Service Pack 2 allows use of

arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for information on Win

dows 2000 service packs.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sin comentarios

D-Link DXS-3600 Series Guía de instalación Pagina 22