D-Link DXS-3600 Series Guía de instalación descargar pdf (Pagina 9)

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide

Front Panel Components

The front panel of the switch consists of LED indicators, an SD card slot, an Out-Of-Band Management port (MGMT), a

Console port, SFP+ ports and an open module slot.

Figure 1-1 Front panel view of the DXS-3600-16S

Figure 1-2 Front panel view of the DXS-3600-32S

Ports that can be found on the front panel of this switch are listed in the table below.

For a complete list of SFP/SFP+/WDM transceivers, that are compatible with this switch, refer to the “Product

Specifications” section in Appendix A.

• Management Information Base (MIBs) for MIBII, Bridge MIB, SNMPv2 MIB, RMON MIB, RMONv2 MIB, Ether-like

MIB, 802.3 MAU MIB, 802.1p MIB, IF MIB, RADIUS Authentication Client MIB, IGMPv3 MIB, RIPv2 MIB, IP Forward

ing Table MIB (CIDR), IPv4 Multicast Routing MIB, PIM MIB for IPv4, RADIUS Accounting Client MIB, Ping MIB,

Trace out MIB, OSPFv2 MIB, VRRP MIB, Private MIB, Entity MIB.

Port Description

SD Card Slot This port can be used to insert an external SD memory card. The maximum capacity

SD card that can be inserted into this port is 32Gb.

Management port (MGMT) This port is a 10/100/1000Mbps Ethernet port with an RJ-45 connection. This Out-

Of-Band management port that can be used to configure this switch without being

connected to the network.

Console port This port is an RJ-45 connection port that can be used to connect to the Command

Line Interface (CLI) of this switch for configuration, management and monitoring.

This port uses a special console cable (included with the packing) with a DB9

interface to connect the Switch to a PC’s COM port.

10 Gigabit ports This switch is equipped with SFP/SPF+/WDM ports. These ports can operate at

10Gbps speeds and support a vast collection of SFP/SFP+/WDM transceivers.

Expansion Module Slot This slot can be equipped with 4 kinds of additional modules. These modules are not

included and should be bought seperately.

• DXS-3600-EM-4XT (Four 10GBASE-T Copper ports).

• DXS-3600-EM-8T (Eight 1000BASE-T Copper ports).

• DXS-3600-EM-4QXS (Four 40Gbps QSFP+ transceiver slots).

• DXS-3600-EM-8XS (Eight 10Gbps SFP+ transceiver slots).

• DXS-3600-EM-Stack (Two 120Gbps CXP Stacking ports). This module can only

be used with the DXS-3600-32S.

• •

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Sin comentarios

D-Link DXS-3600 Series Guía de instalación Pagina 9