D-Link DWL-1800 Especificaciones descargar pdf (Pagina 16)

Using the Configuration Menu (continued)

Advanced > Mode

The DWL-2200AP can be

configured to perform in

any of four modes: a

Wireless Access Point;

a Wireless Bridge; a

Multi-Point Bridge; or a

Repeater.

Access Point - This is

the default setting. This

mode is used to create a

wireless LAN.

PtP Bridge - Allows

you to connect two LANs

together. The wireless

bridge will only work with

another DWL-2200AP.

Click to enable and enter

the MAC address of the

remote bridge.

PtMP Bridge - Allows you to connect multiple wireless LANs together. Other wireless

LANs must be using DWL-2200APs. Click to enable, and enter up to 8 remote AP MAC

addresses.

AP Repeater - Allows you to repeat the wireless signal of the root AP. Click to enable

and enter the MAC address of the root AP.

Apply - Click Apply if you have made any changes.

Find the MAC address of the DWL-2200AP that is acting as a Remote Access

Point or a Remote Bridge, by going to Status > Device Info in the configuration

utility of the remote DWL-2200AP. There you will find the MAC address.

MAC Address - Media Access Control Address

A unique hardware address that identifies a device on a network. It is assigned at

the factory and cannot be changed. Usually you will find this address on a sticker

on the device or on the packaging.

Click Site Survey to see the configuration of the devices on the network.

SSID - The SSID setting is default.

When you Double-click the device you wish to connect to, the MAC/SSID info will

be copied into the correct input boxes.

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 57 58

Sin comentarios

D-Link DWL-1800 Especificaciones Pagina 16