D-Link DWL-1800 Especificaciones descargar pdf (Pagina 45)

1.The computer used to configure the DWL-2200AP cannot access

the configuration menu.

Check that the Ethernet LED on the DWL-2200AP is ON. If the

LED is not ON, check that the cable for the Ethernet connection is

securely inserted.

Check that the Ethernet adapter is working properly. Please see

item 3 (Check that the drivers for the network adapters are

installed properly) in this Troubleshooting section to check that

the drivers are loaded properly.

Check that the IP address is in the same range and subnet as the

DWL-2200AP. Please see Checking the IP Address in Windows

XP in the Networking Basics section of this manual.

Note: The IP address of the DWL-2200AP is 192.168.0.50. All the computers on

the network must have a unique IP address in the same range, e.g., 192.168.0.x.

Any computers that have identical IP addresses will not be visible on the

network. They must all have the same subnet mask, e.g., 255.255.255.0

Do a Ping test to make sure that the DWL-2200AP is responding.

Go to Start>Run>Type Command>Type ping 192.168.0.50. A

successful ping will show four replies.

Troubleshooting

This chapter provides solutions to problems that can occur during the installation and

operation of the DWL-2200AP. We cover various aspects of the network setup, including

the network adapters. Please read the following if you are having problems.

Note: If you have

changed the default IP

address, make sure to

ping the correct IP

address assigned to the

DWL-2200AP.



Note: It is recommended that you use an Ethernet connection to

configure the DWL-2200AP Wireless Access Point.

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Sin comentarios

D-Link DWL-1800 Especificaciones Pagina 45