D-Link DSA-3200 Información técnica Pagina 210
- Pagina / 321
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
xStack
®
DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
196
The following parameters may be viewed or modified:
Parameter Description
LBD State
Use the drop-down menu to enable or disable loopback detection. The default is Disabled.
Mode Use the drop-down menu to toggle between Port-based and VLAN-based.
Trap Status Set the desired trap status: None, Loop Detected, Loop Cleared, or Both.
Interval (1-32767)
The time interval (in seconds) that the device will transmit all the CTP (Configuration Test
Protocol) packets to detect a loop-back event. The valid range is from 1 to 32767 seconds.
The default setting is 10 seconds.
Recover Time (0 or 60-
1000000)
Time allowed (in seconds) for recovery when a Loopback is detected. The Loopdetect
Recover Time can be set at 0 seconds, or 60 to 1000000 seconds. Entering 0 will disable
the Loopdetect Recover Time. The default is 60 seconds.
From Port / To Port
Use the drop-down menus to select a range of ports to be configured.
State Use the drop-down menu to toggle between Enabled and Disabled.
Click Apply to let the changes take effect.
Traffic Segmentation
Traffic segmentation is used to limit traffic flow from a single or group of ports, to a group of ports. This method of segmenting
the flow of traffic is similar to using VLANs to limit traffic, but is more restrictive. It provides a method of directing traffic that
does not increase the overhead of the Master switch CPU.
To view the following window, click Security > Traffic Segmentation:
Figure 6 - 80. Traffic Segmentation window
To configure traffic segmentation on the Switch, first specify the Source Ports using the From and To drop-down menus at the top
of the window. Next, specify which ports on the Switch are able to receive packets from the port(s) specified in the first step.
- Table of Contents 3
- Intended Readers 11
- Safety Cautions 12
- Lithium Battery Precaution 14
- Section 1 15
- Introduction 15
- Web-based User Interface 16
- Web Pages 17
- Configuration 18
- Device Information 19
- System Information 19
- Serial Port Settings 20
- IP Address 20
- Port Configuration 22
- Port Settings 23
- Port Description Settings 25
- Static ARP Settings 26
- Gratuitous ARP 27
- User Accounts 28
- Command Logging Settings 29
- System Log Configuration 30
- System Severity Settings 31
- MAC Address Aging Time 32
- Web Settings 32
- Telnet Settings 33
- Password Encryption 33
- CLI Paging Settings 33
- Firmware Information 34
- Dual Configuration Settings 35
- Power Saving 37
- Power Saving Settings 38
- Power Saving LED Settings 39
- Power Saving Port Settings 39
- MAC Notification Settings 40
- SNMP Settings 41
- SNMP Global State Settings 42
- SNMP View Table 43
- SNMP Group Table 44
- SNMP User Table 45
- SNMP Community Table 46
- SNMP Host Table 47
- SNMP v6Host Table 48
- SNMP Engine ID 48
- SNMP Trap Configuration 49
- Single IP Management 50
- Upgrade to v1.61 51
- Single IP Settings 52
- Topology 53
- Tool Tips 55
- Right-Click 56
- Group Icon 56
- Commander Switch Icon 57
- Member Switch Icon 58
- Candidate Switch Icon 58
- Firmware Upgrade 60
- Upload Log File 60
- SD Card Backup Settings 62
- SD Card Execute Settings 62
- L2 Features 64
- IEEE 802.1Q VLANs 65
- 802.1Q VLAN Tags 66
- Port VLAN ID 67
- Tagging and Untagging 67
- Ingress Filtering 68
- Default VLANs 68
- Port-based VLANs 68
- VLAN Segmentation 69
- VLAN and Trunk Groups 69
- 802.1v Protocol VLAN 72
- GVRP Settings 74
- MAC-based VLAN Settings 75
- Private VLAN Settings 75
- PVID Auto Assign Settings 78
- Voice VLAN 78
- Voice VLAN Port Settings 79
- Voice VLAN OUI Settings 80
- Voice VLAN Device 80
- VLAN Trunk Settings 81
- Browse VLAN 82
- Egress Filter Settings 83
- L2 Multicast Control 83
- IGMP Snooping 84
- IGMP Router Port 88
- IGMP Snooping Counter 89
- IGMP Host Table 90
- MLD Snooping 91
- MLD Router Port 95
- MLD Snooping Counter 97
- Multicast VLAN 98
- Multicast Filtering 101
- Multicast Filtering Mode 103
- Port Mirroring 104
- Spanning Tree 105
- Port Transition States 106
- Edge Port 106
- P2P Port 106
- STP Bridge Global Settings 107
- STP Port Settings 108
- STP Instance Settings 111
- MSTP Port Information 111
- Link Aggregation 112
- Forwarding & Filtering 115
- Multicast Forwarding 116
- LLDP Global Settings 117
- LLDP Port Settings 118
- LLDP Management Address List 119
- LLDP Basic TLVs Settings 119
- LLDP Dot1 TLVs Settings 120
- LLDP Dot3 TLVs Settings 121
- LLDP Statistics System 122
- LLDP Local Port Information 123
- LLDP Remote Port Information 124
- LLDP-MED 125
- NLB FDB Settings 127
- L3 Features 129
- IPv6 Interface Settings 130
- IPv6 Route Settings 131
- IPv6 Neighbor Settings 131
- Section 5 133
- Understanding QoS 134
- Bandwidth Control 135
- Traffic Control 136
- 802.1p Default Priority 139
- 802.1p User Priority 139
- QoS Scheduling Mechanism 140
- Security 141
- RADIUS Accounting Settings 142
- RADIUS Authentication 143
- RADIUS Account Client 144
- IP-MAC-Port Binding (IMPB) 145
- ARP Mode 146
- ACL Mode 146
- Strict and Loose State 146
- IMPB Global Settings 147
- IMPB Port Settings 148
- IMPB Entry Settings 149
- MAC Block List 150
- DHCP Snooping 151
- ND Snoop 152
- Port Security 153
- Port Lock Entries 154
- DHCP Server Screening 155
- DHCP Offer Filtering 156
- Authentication Server 158
- Authenticator 158
- Authentication Process 159
- 802.1X Global Settings 162
- 802.1X Port Settings 163
- 802.1X User Settings 165
- Guest VLAN Settings 165
- Authenticator State 166
- Authenticator Statistics 166
- Authenticator Diagnostics 168
- SSL Settings 171
- SSL Certification Settings 173
- SSH Settings 174
- SSH User Authentication List 176
- Enable Admin 178
- Authentication Server Group 179
- Login Method Lists Settings 182
- Enable Method Lists Settings 183
- WAC Global Settings 190
- WAC User Settings 191
- WAC Port Settings 192
- WAC Authenticating State 193
- WAC Customize Page 193
- JWAC Global Settings 194
- JWAC Port Settings 196
- JWAC User Settings 197
- JWAC Authentication State 198
- JWAC Customize Page Language 199
- JWAC Customize Page 199
- Compound Authentication 200
- 802.1X & IMPB Mode 201
- IMPB & WAC/JWAC Mode 202
- MAC & IMPB Mode 202
- IGMP Access Control Settings 206
- BPDU Attack Protection 208
- Loopback Detection Settings 209
- Traffic Segmentation 210
- Safeguard Engine Settings 211
- Trusted Host Settings 212
- Section 7 214
- ACL Configuration Wizard 214
- Access Profile List 215
- CPU Access Profile List 229
- Time Range Settings 242
- Network Application 244
- DHCPv6 Relay 247
- DHCP Server 248
- DHCP Server Global Settings 249
- DHCP Server Pool Settings 250
- DHCP Server Manual Binding 251
- DHCP Local Relay Settings 252
- DHCP Option 12 Settings 254
- DNS Resolver 254
- SMTP Settings 257
- SNTP Settings 258
- Ping Test 260
- Section 9 262
- Ethernet OAM 262
- Ethernet OAM Event Log 264
- Ethernet OAM Statistics 264
- DULD Settings 265
- Cable Diagnostics 266
- Cable Diagnostics Notes 267
- Monitoring 268
- DRAM & Flash Utilization 269
- Port Utilization 270
- Packet Size 270
- Packets 272
- UMB_Cast (RX) 274
- Transmitted (TX) 275
- Received (RX) 277
- Browse ARP Table 280
- Browse Router Port 280
- Browse MLD Router Port 281
- Browse Session Table 281
- IGMP Snooping Group 282
- MLD Snooping Group 282
- MAC Address Table 283
- System Log 284
- Save and Tools 285
- Save Configuration 286
- Save Log 286
- Save All 287
- Download Firmware to SD Card 288
- Reboot System 290
- Using Packet Content ACL 291
- Ethernet Header 294
- Example topology 295
- Appendix D – Trap Logs 318
Relacionado con productos y manuales para Redes D-Link DSA-3200
Redes D-Link DSL-300 Manual de usuario
(5 paginas)
(5 paginas)
Redes D-Link ShareCenter Pulse DNS-320 Manual de usuario
(111 paginas)
(111 paginas)
Redes D-Link DHP-306AV Manual de usuario
(56 paginas)
(56 paginas)
Redes D-Link DVG-2032S Manual de usuario
(3 paginas)
(3 paginas)
Redes D-Link DSL-320T Guía de usuario
(66 paginas)
(66 paginas)
Redes D-Link 502G - DSL Router - EN Guía de usuario
(73 paginas)
(73 paginas)
Redes D-Link DSL-320B Manual de usuario
(40 paginas)
(40 paginas)
Redes D-Link 707P - DI Router Especificaciones
(109 paginas)
(109 paginas)
Redes D-Link AirPlus G DWL-G510 Especificaciones
(47 paginas)
(47 paginas)
Redes D-Link DGE-550SX Guía de usuario
(25 paginas)
(25 paginas)
Redes D-Link DI 704 - Gateway Manual de usuario
(47 paginas)
(47 paginas)
Redes D-Link ShareCenter DNS-315 Manual de usuario
(79 paginas)
(79 paginas)
Redes D-Link DCM-301 Manual de usuario
(20 paginas)
(20 paginas)
Redes D-Link DWL-3600AP Guía de instalación
(4 paginas)
(4 paginas)
Redes D-Link xStackTM DGS-3300 Manual de usuario
(5 paginas)
(5 paginas)
Redes D-Link DI-206 Manual de usuario
(15 paginas)
(15 paginas)
Redes D-Link DAP-3220 Manual de usuario
(84 paginas)
(84 paginas)
Redes D-Link DWR-510 Manual de usuario
(62 paginas)
(62 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales