
D-Link Product Guide 2008
90
WIRED
ETHERNET
MEDIA CONVERTERS
● SNMP/Web-Based Standards
● 10/100BASE-TX Ethernet & RS-232
Console Ports
● Real-Time Display of Link, Speed,
Duplex Status of Media Converters
● Menu-Driven Terminal Program for
Management via Console Port or
Telnet
● Built-in SNMP Agent
● Supported Traps: Cold start, Warm
Start, Authentication Fail, Power Fail,
Fan Fail, Module Insertion, Module
Pullout, Port Link Down, Port Link Up
● Factory Reset & Remote Software
Reboot
● Remote Setting of Configurations
of Smart Media Converters (LLCF
Enable, LLR Enable, Port Enable,
Auto-Negotiation Enable)
● Configuration Setting Upload/
Download Through TFTP/Web
● TFTP/Web-Based Firmware Upgrade
Twisted-Pair to Fiber Ethernet
WDM Media Converter
Management Module
● Converts 10/100BASE-TX to
100BASE-FX Fiber Signals
● Uses in Pair With DMC-920R or
Equivalent Device
● Extends Network Distance Up to 20
km on Single-Mode Fiber Cable
● Converts 1000BASE-T Gigabit Twisted-
Pair to 1000BASE-LX Gigabit Fiber
Signals
● Uses in Pair With DMC-1910R or
Equivalent Device
● Up to 15 km Single-Mode Fiber Cable
Length
Twisted-Pair to Fiber Gigabit
WDM Media Converter
Twisted-Pair to Fiber Gigabit
WDM Media Converter
● Converts 1000BASE-T Gigabit Twisted-
Pair to 1000BASE-LX Gigabit Fiber
Signals
● Uses in Pair With DMC-1910T or
Equivalent Device
● Up to 15 km Single-Mode Fiber Cable
Length
Media Converter Chassis
● 16 Bays to House Up to 16 Media
Converters
● Standard 19-Inch Rack-Mountable
● Hot Swapping of Media Converters
● Hot Swappable Redundant Power
Supply
● Power Redundancy & Power Isolation
● 1 Universal Internal AC to DC Power
Supply Provided
● Second AC to DC Power Supply for
Load-Sharing Purposes (Optional)
● Media Converter Power Isolation for
Electrical Isolation From Each Bay
The stand-alone media converters are stand-alone devices that plug directly to the
network switches, installed independently of any media converter chassis. They are
cost-effective devices that convert twisted-pair Ethernet cable signals to fiber Ethernet
cable signals.
Twisted-Pair to Fiber Ethernet Media Converter
● Converts 10/100BASE-TX to 100BASE-FX Signals
● Extends Network Distance Up to 2 km on Multi-Mode Fiber Cable
Redundant Power Supply
● 90 to 260 VAC/47 to 63 Hz Auto-
Switching Input Power
● Power Overload Protection
● Load Sharing Support When 2 of This
RPS Installed in DMC-1000 Chassis
Comentarios a estos manuales