D-Link DIR-68 Manual de usuario descargar pdf (Pagina 33)

29D-Link DIR-610N User Manual

Section 3 - Conguration

This will allow you to open a single port. If you would like to open a range of ports, refer to”Port Forwarding” on page 30.

Check the box to the left of the rule to activate that particular

virtual server rule.

Enter a name to identify the rule, or select an application from

the drop-down menu and click << to automatically populate

the elds.

Enter the IP address of the computer on your local network that

you want to allow the incoming service to. If your computer is

receiving an IP address automatically from the router (DHCP),

you computer will be listed in the “Computer Name” drop-down

menu. Select your computer and click << to populate the eld.

Enter the port that you want to open next to Private Port and

Public Port. The private and public ports are usually the same. The

public port is the port seen from the Internet side, and the private

port is the port being used by the application on the computer

within your local network.

Select TCP, UDP, or All from the drop-down menu.

Click Save Settings to save the current conguration, or click

Don’t Save Settings to discard any changes.

Checkbox:

Name:

IP Address:

Private Port/

Public Port:

Protocol:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 74 75

Sin comentarios

D-Link DIR-68 Manual de usuario Pagina 33