D-Link DSA-3200 Manual de usuario descargar pdf (Pagina 27)

VARIABLE QPKTS

VALID VALUES 0 or 1

DEFAULT VALUE 0

DATA TYPE integer

DESCRIPTION This switch will control the action the DSA will take when the data buffer is

full.

0 - frames will be discarded when the data buffer is full. The DSA

will continue to scan.

1 - no frames will be lost. The DSA will stop scanning and log an

error if the data buffer is filled.

VARIABLE S I M <code>

VALID VALUES 0, or 1

DEFAULT VALUE 0

DATA TYPE Integer

DESCRIPTION Determines the source of the data samples.

0 - Data are taken from the sensors

1 - Data are generated internally

VARIABLE TIME <code>

VALID VALUES 0, 1, or 2

DEFAULT VALUE 0

DATA TYPE Integer

DESCRIPTION Determines the format of the Time Stamp.

0 - No Time Stamp

1 - Time stamp data are in microseconds

2 - Time stamp data are in milliseconds

VARIABLE UNITSCAN

VALID VALUES see list below

DEFAULT VALUE PSI

DATA TYPE string

DESCRIPTION Unit scan factor. This sets the scan units for the DSA. Setting this value will

also set CVTUNITS. CVTUNITS may be set to a different value, however

UNITSCAN must be set first. The following are the list of units supported

ATM FTH2O KGM2 MH2O OZFT2

BAR GCM2 KIPIN2 MMHG OZIN2

CMHG INHG KNM2 MPA PA

CMH2O INH2O KPA NCM2 PSF

DECIBAR KGCM2 MBAR NM2 PSI

TORR

If a value other than those listed is entered, PSI will be used. It is best to use

uppercase when entering these units.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Sin comentarios

D-Link DSA-3200 Manual de usuario Pagina 27