D-Link DSA-3200 Manual de usuario descargar pdf (Pagina 39)

6. Modify the parameters as required by typing the change command at the [VxW orks Boot]

prompt

Type: c<Enter> The boot-loader prompts you for each parameter.

If a particular field has the correct value and does not need to be changed,

Press: <Enter>

NOTE: If any other key is pressed, that will replace the existing information.

To clear a field,

Type: . <Enter>

To quit before viewing all of the parameters,

Type: CTRL+D.

7. After all changes have been made, verify the settings:

Type: p<Enter> The settings are saved in flash at this point.

8. Restart the operating system, with the new settings,

Type: @<Enter> This is the “Load and Go” command.

9. If the DSA3200 boots correctly, de-energize the DSA3200 and disconnect the serial test

cable.

10. Re-apply power to the DSA3200.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 51 52

Sin comentarios

D-Link DSA-3200 Manual de usuario Pagina 39