D-Link DSA-3200 Manual de usuario descargar pdf (Pagina 40)

Boot parameters and their functions:

boot device Must not be changed from cs

processor number Must not be changed from 0

host name Must not be changed from host.

file name The full pathname of the operating system file name to be booted from,

when booting from the network. The default path and file in this line is the

path and file used at Scanivalve.

inet on ethernet(e) The internet address of this DSA3200. The subnet mask may be specified

when entering this parameter by entering a colon followed by the subnet

mask in hex notation. I.e. 191.30.85.100:FFFFFF00

inet on backplane (b) Must be left blank

host inet (h) The internet address of the host to boot from.

gateway inet (g) The internet address of a gateway node if the host is not on the same

network as the DSA3200.

user (u) The user name that the DSA3200 uses to access the host. This is the name

that must be set up in the FTP server on the host. The FTP server must be

set up to provide that user name with the proper permission to read from the

host directory and the password must be set correctly.

ftp password (pw) The user password. This must be supplied to boot from host.

flags (f) Must be 0x0

target name (tn) Must be blank

startup script (s) Must be blank

other (o) This specifies the place to boot from, the MAC address, and the network

media. The line must not contain any spaces and each parameter is

separated by a comma. The syntax is:

Valid values are case sensitive and are as follows:

<bootloc> net - Boot from network

flash - Boot from flash.

<mac address> ddd.ddd.ddd.ddd.ddd.ddd

<media type> 10base2 - 10Base2 type

10baset - 10BaseT type

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Sin comentarios

D-Link DSA-3200 Manual de usuario Pagina 40